10" Twinflex Top Plate
In stock
SKU
10TP
- Steel Construction
- For Use With Top Clamp
- Fits to top of Chimney Stack
- UK Manufactured
- Genuine Twinflex Component
10" Twinflex Top Plate
Fits to top of chimney stack and allows the flue liner to pass through. Used with top clamp.
- Steel Construction
- For Use With Top Clamp
- Fits to top of Chimney Stack
- UK Manufactured
- Genuine Twinflex Component
Construction | Galvanised Steel |
---|---|
Fuel Type | Dry Logs, Peat, Oil, Gas, Open Coal Fires & Smokeless fuels |
Suitable For Condensing | No |
Building Regulations | Document J |
Installation Guide: | After Installing the liner at the top of the chimney stack, place the top plate over the liner at the point of termination. The plate should now be on top of the chimney stack. Now use a top clamp (purchased separately) to secure the liner above the plate. If you are fitting a cowl, remember to leave approximately 100mm of liner above the plate so it can be secured. Once the liner has been secured, finish by covering the top plate and clamp with sharp sand and cement. |