6" IL Draughthood Connector
In stock
SKU
ILDHC06
- Twin Lined System
- Air Gap insulated
- Aluminium Lined
- Zalutite Outer Casing
- Strong rigid System
6" IL Draughthood Connector
This component must be used to connect the system to an appliance spigot and also where the system is connected to a Transfer or Adaptor block for a BS EN 1858 Flue Block system.
It cannot be used as a substitute for the Adaptor to Flue Liner.
- Twin Lined System
- Air Gap insulated
- Aluminium Lined
- Zalutite Outer Casing
- Strong rigid System
| Designation: | BS EN 1856-1: T250 N1 D VmL11030 0(50) |
|---|---|
| Construction | Aluminium liner protected by an outer casing of Zalutite |
| Warranty | 5 years |
| Fuel Type | IL gas vent is suitable for gas appliances, typically in domestic or small commercial installations |
| Suitable For Condensing | No |
| Component Type | Adaptor |
| Building Regulations | Document J |
| Installation Guide: | Always use a Draughthood Connector to connect the IL system to the appliance spigot or draughthood. The inner lining must be fitted inside, but NOT project below the spigot/ outlet and can be cut to an appropriate length |